Baileigh DP-4016B, Руководство оператора

Страница: 19 / 40

17
17
ASSEMBLY AND SET UP
Two Person Lift. A lifting device will be
needed, and an assistant is highly recommended.
Use an assistant or lifting devise (recommended) to
support the weight of the drill head during assembly.
1. Open the carton and inspect the contents.
2. Lift the base, column, and table assembly out of
the carton and position where the drill is intended
to be placed.
3. Use the mounting holes as a template and mark
the location on the bench for the anchor bolts.
4. Install the anchor bolts (customer supplied) and
secure the base, column, and table assembly to
the bench with the anchor bolts.
5. Check that the stop collar (A) is secure to the
column.
6. Using an appropriate lifting devise, carefully lift the
head assembly out of the carton and over the
column.
7. Insert the column into the pocket on the bottom of
the head assembly until the column is fully seated
into the head pocket.
8. Install the slip wedge pin and clamping bolt
assembly into the casting with the taper (B)
toward the column. (Taper shown up for visibility.)
9. Install the treaded wedge pin in from the opposite
side and lightly tighten the clamping bolt.
WARNING:
For your own safety,
DO NOT connect the machine to the power
source until the machine is completely
assembled and you read and understand the
entire instruction manual.
B
A