Baileigh DP-1512B, Руководство по эксплуатации

Страница: 18 / 32

16
16
8. Using a second person a suitable and secure lifting devise, carefully lift the head assembly
(4) above and onto the column top and slide it down into position. The head assembly is
heavy! Use care when lifting onto the column!
9. Rotate head assembly until the spindle is positioned directly over the front of the base. Use
a plumb bob to assist with proper location.
10. Tighten two setscrews to lock the head to the column.
11. Install three feed handles (6) into the down-feed hub.
Chuck and Arbor Installation
1. Place a piece of scrap wood on the table to protect the chuck nose.
2. Twist the chuck to retract the chuck jaws if they are exposed.
3. Install the chuck to the arbor tightly.
4. Insert the chuck and arbor assembly into the spindle. Pull the down-feed handle down to
press the arbor in place.
Chuck and Arbor Removal
1. Disconnect the machine from the power source.
2. Raise the table until it is about seven inches below the chuck.
3. Place a piece of scrap wood on the table, and lower quill using the down-feed handle.
4. Rotate spindle to align the keyhole in the spindle with the keyhole in the quill.
5. Insert the drift key into the aligned slots and tap lightly. The chuck and arbor assembly
should fall from the spindle.
WARNING:
Change the radial position of the drill head only if the drill
press base is secured to the floor. Swinging the drill head without the base being
secured to the floor will cause the drill press to become unstable and tip over
resulting in injury and/or damage to the machine.