Baileigh Industrial SS-2725, Руководство оператора

Страница: 37 / 56

34
34
Contour Edge Shaping with Collar Bearing
To shape contoured edges, the operator must first remove
the fence assembly.
In order to control the workpiece and limit the depth-of-cut,
the operator must use an anti-friction collar with the
cutter(s).
The collar may be positioned above or below the cutter (s),
and its function is to ride against the workpiece or template.
At the same time, the collar will establish the depth-of-cut as
shown. Whenever possible, always use the ring guard.
Note: Since the collar requires at least 1/8" of
surface edge to ride against, the entire edge cannot be
shaped. The use of a pattern, however, permits the
shaping of the entire contour edge.
If the workpiece is to be shaped all around the
perimeter, hold it firmly and push the work straight
into the cutter until the depth of cut is established by
the collar.
Continue to feed the work so that the point of contact
on the edge is always 90 degrees to the collar (or
directly in line with the cutter edge) and geld firmly
against it.