Baileigh Industrial IP-2209-HD, Руководство оператора

Страница: 31 / 60

28
28
PRESSURE BAR ADJUSTMENT
The pressure bar should be set even with the
lowest point of knife.
1. Disconnect machine from power source.
2. Place a hard wood gauge under a knife in
cutterhead. Raise table until wood gauge
contacts the knife in its lowest position.
3. Place wood block (A) under the left side of
pressure bar (B). The top of wood gauge should
just contact the pressure bar. If it doesn’t,
loosen jam nut (C) and turn the adjusting screw
(D) to raise, or lower the pressure bar until it
contacts wood gauge.
4. Repeat for opposite side of the pressure bar.