Baileigh Industrial IP-2209-HD, Руководство оператора, Страница: 30 / 60

27
27
5. If it doesn’t, loosen jam nut (C, Fig 14) and turn the adjusting screw (D, Fig 14) to raise, or
lower the in-feed roller until it contact the wood gauge.
6. Repeat for opposite side of the in-feed roller.
CHIPBREAKER ADJUSTMENT
Chipbreaker should be set 0.02” below the lowest point of knife. Make sure the knives are set
properly. See the “Setting / Changing Knives” section prior to making any adjustments.
1. Disconnect machine from power source.
2. Place a hard wood gauge (A, Fig 13) under a knife in the cutterhead.
3. Place a 0.02” feeler gauge (B, Fig 13) on top of wood block and raise table until the gauge
contacts the knife in its lowest position.
4. Remove feeler gauge and place wood gauge
(E, Fig 15) under the left side of chipbreaker (F,
Fig 15).
5. The top of the wood gauge should just contact
the chipbreaker.
6. If it doesn’t, remove the socket head cap screw
(G, Fig 14) and remove washer (H, Fig 14), or
replace with shim of proper thickness to raise,
or lower the chipbreaker until it contacts the
wood gauge.
7. Repeat for opposite side of the chipbreaker.