35
35
LUBRICATION AND MAINTENANCE
Daily Maintenance
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Do a general cleaning by removing dust and metal chips from the machine.
•
Top off the coolant tank. (80% of full tank capacity)
•
Inspect the disk/saw blade for wear.
•
Check that the blade guard, shields, and emergency stops are in good working order.
•
When through using machine, raise the head to reduce stress on the return spring.
Weekly Maintenance
•
Clean the machine including the coolant tank and the area around it.
•
Lubricate threaded components and sliding devices.
•
Clean and grease the vise screw and sliding surfaces.
•
Clean the guard housing for the disk/saw blade.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
•
Sharpen the saw teeth.
Monthly Maintenance
•
Thoroughly clean the machine including the coolant tank.
•
Check that all screws on the motor, the pump, the vise jaws, and
the guard are tight and secure.
•
Check that the saw guard is operating properly.
•
Use an EP90 or similar oil to lubricate the saw head pivot (A) and
the saw miter pivot.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
A
Содержание CS-350EU
