Baileigh Industrial CS-350EU, Руководство оператора

Страница: 28 / 60

25
25
Setting Cut Length
Setting the cut length eliminates measuring duplicate
pieces.
1. Measure and mark the length of material to be cut off.
2. Load the piece part.
3. Line up the cut.
4. Clamp the piece part.
5. Loosen the hand knob (A) at the base of the bar riser.
6. Slide the bar riser along the long rod (B) so that the tip of stop bar (C) touches the end of the
piece part.
7. Tighten the hex nut at the base of the bar riser (A).
Using the stop bar
1. Cut off the first length from the clamped piece part.
2. Unclamp the piece part.
3. Slide the piece part forward until it reaches the tip of the stop bar (C).
4. Clamp the piece part.
5. Proceed with the cutting cycle.
A
C
B