Baileigh Industrial BS-712M, Руководство оператора

Страница: 35 / 56

32
32
5. Loosen the two hex bolts (V) as indicated.
6. Turn setscrew (W) while observing blade tracking on the pulley. Turn
the setscrew clockwise (cw) to track the blade closer to the pulley
flange. Turn the setscrew counterclockwise (ccw) to track the blade
away from the pulley flange.
7. Once the tracking is set, tighten the two hex bolts (V).
Blade Guide Adjustment
1. Disconnect saw from the power source.
2. Loosen kn
obs “D” and “E”.
3. Slide the blade guide assemblies as close as
possible to the work piece without interfering with the
cut or vise.
4.
Tighten knobs “D” and “E”.
5. Reconnect the saw to the power source.
Adjusting Blade Guide Bearings
The blade guide bearings have been adjusted at the
factory. Over time, an adjustment will become necessary
due to uneven blade wear or skewed cuts. The side
bearings have an eccentric shaft to allow for side to side
adjustment.
1. Disconnect power to the saw.
2. Move the saw bow to the vertical position and lock in
place by turning off the hydraulic cylinder valve.
3. Loosen cap screw (X) in figure at right and adjust the
bearing assembly so that the back-roller bearing is
approximately .003”-.005” (.07mm - .13mm) from the
back of the blade.
4.
Turn nut(s) (Y) to adjust for a .001” - .002” (.02 - .05mm)
side clearance between the bearing and the blade.
5. Repeat the procedure for the side clearance of the other
bearing assembly. This assembly has no back-bearing
adjustment.
V
W
D
E
(.07 - .13mm)
(.02 - .05mm)
.003"-.005"
.001" - .002"
X
Y