Baileigh Industrial BMS-10, Инструкция по эксплуатации и каталог запасных частей

Страница: 16 / 48

Figure 6-3
5. Allow cover plate and guard to fall backward, to
expose arbor bolt (L, Figure 6-4).
6. Press and hold arbor lock on opposite side of
head (Figure 6-5) while rotating blade until arbor
lock engages.
7.
Continue pressing arbor lock, while loosening
arbor bolt with hex wrench.
NOTE: Left-hand
threads – turn clockwise to loosen.
Figure 6-4
Figure 6-5
8. Remove arbor bolt, outer flange, and blade. (On
model BMS-12, also remove reducer sleeve). Do
not remove inner flange.
Note: Pay attention to the pieces removed, noting
their position and direction they face. Wipe pieces
clean of any sawdust before installing a new
blade.
Figure 6-6
Important : Make sure blade size and arbor hole
match specification of miter saw.
9. Install new blade. Rotation arrow on blade must
match clockwise rotation arrow on upper guard,
and the blade teeth must point downward.
10. Place flange outer flange against blade and on
arbor. Thread arbor bolt onto arbor in
counterclockwise direction.
11. Important: Make sure flat edge inside flange
opening is aligned with flat edge on arbor shaft.
Also, the flat side of the flange must be placed
against blade.
12. Press and hold arbor lock (Figure 6-5) while
rotating blade until arbor lock engages.
13. Tighten arbor bolt.
14. Rotate cover plate back to original position, until
slot in cover plate engages completely with cover
plate screw (K, Figure 6-3). While holding lower
blade guard up as shown in Figure 6-3, tighten
screw.
15.
Lower blade guard and verify that it operates
smoothly without binding or sticking.
16