Baileigh Industrial 1000568, Руководство оператора

Страница: 22 / 40

20
20
5. If using a full length clamping bar, use the lift
handles (A) to raise the clamping bar and then
position the piece part under the clamp bar. Use
the backstop if needed.
IMPORTANT: NEVER activate the
magnetic circuit with the clamping bar raised. The bar
will snap down possible causing injury and or
damaging the bar, the magnet table, or the material.
6. Lower the clamping bar to allow the weight of the
bar to hold the material for final positioning.
7.
Switch the toggle switch up to the “BEND position and step down on the footswitch or press
any one of the three GREEN start switches to apply the pre-clamping force. (See fig. 8)
8. Now that the piece part is held in place, pull up on the bending leaf handles. This will activate
the micro-switch which tells the electro-magnet to apply full clamping force. Continue pulling
up on the handles until the desired bend angle is made.
9. The left handle has a leaf angle indicator that is shown in (fig. 9). To
allow for springback of the material, bend a few degrees more than
the required angle. Read the section Understanding springback.
There is also a locking collar on the indicating shaft which can be set
and locked to duplicate multiple bends.
10. After the bend is made, lower the bending leaf. DO NOT ALLOW
THE BENDING LEAF TO SLAM BACK TO THE LOWER
POSITION!
11. Press the stop footswitch or the stop button.
12. When the stop pedal or button the internal timer circuit is activated to
reverse the current to the magnet creating a demagnification cycle.
This circuit is set to 3 seconds and is used to release the magnetic
field on the clamping bar.
figure 9
figure 8
A