Baier BDN 452, Инструкция по эксплуатации

Страница: 21 / 44

| 21 |
BDN 463 / 4 and BDN 464 / 4
•
15 With a cutting width of 18 mm, a clean
chase is formed without a ridge.
•
14 If the cutting width is larger than 18 mm,
use a suitable tool (e.g. chisel, BAIER BMH 622
chipping hammer) to break out the ridge in the
chase.
BDN 466 /6
•
15 With a cutting width of 26 mm, a clean
chase is formed without a ridge.
•
14 If the cutting width is larger than 26 mm,
use a suitable tool (e.g. chisel, BAIER BMH 622
chipping hammer) to break out the ridge in the
chase.
BDN 452, BDN 453, BDN 454, BDN 455,
BDN 463 / 4, BDN 464 / 4 and BDN 466 / 6
NOTE
Blunt diamond dry-cutting discs can be
resharpened if necessary using BAIER whetstones
or other suitable materials.
Note and follow the information and instructions
on handling diamond dry-cutting discs (see
page 22).
6 Cleaning
DANGER
Risk of injury due to electric shock.
Î
Disconnect the mains plug before carrying out
any work on the diamond channel cutter.
The machine must be cleaned after each cutting
work session.
•
Carefully clean the machine and blow out with
compressed air.
•
Ensure handles are dry and free from grease.
7 Maintenance
DANGER
Risk of injury due to electric shock.
Î
Disconnect the mains plug before carrying out
any work on the diamond channel cutter.
The diamond channel cutter must be serviced at
least once a year. Further, servicing will be neces -
sary depending on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may carry
out maintenance of the machine. Also ensure that
original BAIER spare parts and original BAIER
accessories only are used.