Baicells Atom ID0406-6.5, Руководство пользователя, Страница: 13 / 39

8
• Lan State - The CPE connection to the Local Area Network will be either Link Up or Link Down . If
the link is down, recheck the installation steps, make sure the CPE is powered on, and check the
router or other LAN device operation.
• Devices Connected - A count of the number of different smart devices using the CPE
4. Connect Wi-Fi:
a. Ensure that the computer or other smart device has Wi-Fi (WLAN) enabled.
b. When the Wi-Fi LED on the unit shows “steady on”, per Table 2, it is functional. The Wi-Fi function
can be enabled or disabled through the GUI.
c. Looking at the label on the back of the Atom unit, record the WLAN Name and WLAN Key
(WPA/WPA2) values (Figure 9).
Figure 9: Label
To avoid unauthorized use of the Wi-Fi/WLAN, go
to the GUI and modify the WLAN Name and Key
(WPA/WPA2) information from your service
provider. These fields are case-sensitive. On your
Wi-Fi enabled computer and other smart devices,
you can then look for the new Wi-Fi/WLAN
network name.
6.3 Configure WAN Settings
The Network > WAN Settings pertain to:
• How the CPE interfaces with the Wide Area Network (WAN) - typically the Internet;
•
The network or operation mode, which determines how IP addressing is handled; and
• The Domain Name System (DNS) to be used.
Because the GUI screens for the WAN settings are laid out differently between CAT4 and CAT6/7, each is
described separately in the sections below. Refer to Table 4 for a description of all fields in both GUIs.