19
Figure 3-12: Grounding Protection
3.5 Power on to Check LEDs
With all components connected locally, power on the eNB unit. Wait a few minutes, and then
check the LEDs (Figure 3-13). They should illuminate per the descriptions that were provided
in
Table 2-2
.
Figure 3-13: LEDs
After checking to see that all connections are secure and the eNB hardware is operating as
intended, go to the next step in section 3.6 to enter the basic configuration settings. If the eNB
is not operating properly and you have double-checked that all steps up to this point were
completed correctly, please contact
