4
www.stairslight.com
LED Lighting
STX-1795 can control the backlight done by LED strips and 12V LED lights (not 230V!). Strips are
usually mounted under the steps, and the LED lights by the side of the steps. Connections between
lighting elements are shown on the following illustrations.
LED strips
A popular way for backlighting stairs is to use LED strips. In the case of the STX-1795 controller,
one-color strips (mono) should be used. Any color can be chosen. To control colored bands (RGB)
there is the dedicated STX-1793 controller. The standard supply voltage is 12V. The controller can
also be connected to 24 V LED strips, but because of the controller electronics, the voltage should
not be exceeded.
Instalacja elektryczna stopni schodów - taśmy LED
Electrical installation LED strips
LED strips are usually placed under the steps. Points (+) should be connected together and by
a single 1.5 mm2 wire fed to the controller. Points (-) of LED strips should be connected by separate
wires of 0.5 mm2 to the controller, as shown above.
You can also use one pair of wires 0.5 mm2 for each LED strip to the controller separately. Both
solutions are equivalent.
