MAINTENANCE & SUPPORT
> Maintenance
> Cleaning your speaker
> About your Wi-Fi connection
> Charging or powering a USB device
> Enter setup mode manually
> Factory reset your speaker
Maintenance
Refer all servicing of your speaker to qualified
service personnel. Servicing is required when
your speaker has been damaged in any way or
ceases to operate normally. Seek qualified service
in instances of damage to your speaker’s power
supply cord or plug, damage caused by liquid or
exposure to rain or moisture, damage from foreign
objects, or if your speaker has been dropped.
Cleaning your
speaker
Before cleaning your speaker, always unplug it from
the wall socket. Use a dry, lint-free cloth to gently
wipe the surface.
Never use soap, detergents, or aerosol cleaners!
About your Wi-Fi
connection
By its nature, wireless LAN may experience
radio interference depending on environmental
conditions (such as wireless router performance,
distance, obstruction, interference with other
wireless devices, etc.)
Depending on the wireless router used, some
network operations may perform differently.
For detailed information on networking
with a wireless router or modem, refer to its
documentation.
Charging or
powering a USB
device
The USB output connector on the bottom of your
speaker can be used to charge or power your phone
or MP3 player.
01. Insert a USB Type A cable into the USB 5VDC
output located on the bottom of your speaker.
02. Insert the other end of the cable into the USB
connector on your device.
Enter setup mode
manually
When your speaker is new out of the box it will
enter setup mode automatically when connected
to power. If you move or change the Wi-Fi network
settings set your speaker in setup mode manually.
03. Turn the SOURCE knob to .
04. Push and hold until the ring of lights around it
blink continuously to clear all previous Wi-Fi
network connections.
05. Continue with the setup. See First time setup.
Factory reset your
speaker
Factory reset clears all custom settings, presets,
Wi-Fi settings, and Bluetooth pairings from your
speaker.
01. Press and hold the VOLUME and SOURCE
knobs at the same time for 7 seconds until
both the SOLO and MULTI indicators are lit.
02. Your speaker will reset to its factory state after
about 1 minute. It is then restored to setup
mode and is ready to be configured. See First
time setup.