14
15
Introduction
The robotic pool Norkel is a new type of highly efficient and energy-saving swimming pool
cleaning robot. Through its advanced computer-controlled program, it can clean the pool
walls and bottom automatically. At the same time, it filters the pool water and gets rid of
suspended particles without replacing the pool water. It’s totally environmental-friendly.
For safe operation, the cleaner is powered by a rechargeable lithium battery (25.9V 7.8Ah).
Safety
• Cleaner’s position when charging:
• The cleaner needs to be placed in proper position so as to reach the distal end of pool for
the cleaner, meanwhile at least 3.5m from pool edge.
• Use the original adapter only.
• Power off the cleaner when charging.
• Do not power on the cleaner for pool cleaning when charging.
• The cleaner should be charged every three months if it needs to be stored for a long time
to maintain battery life (more than 3 months: 23±5°C, 65±20%RH, at least 80% battery
remaining capacity).
• It is forbidden to collide the battery box with sharp parts and to fall or impact the it!
• It is forbidden to use the cleaner in an environment above 60°C.
• It is forbidden to charge it in the environment below 0°C.
Specifications
• Name: Norkel
• Model: Norkel
• Working voltage: 29.4V
• Power: 130W
• Working Cycle: Max. 120min
• Rated input voltage of adapter: 100Vac-240Vac
• Input power of adapter: 50Hz/60Hz
• Rated output current of adapter: 2A
• Rated output voltage of adapter: 30V
• Charging time: 4-5h
• Battery capacity: 7800mAh
• Max. cleaning surface: 120m²
• Filter capacity: appr. 16m³/min
• Filter capability: 180μm
• Pool water temperature: 10°-35°C
• Moving speed: appr. 10m/min
• IP Grade: IPX8
• Working environment temperature:
charging: 0°C-40°C; discharging: -20°C-60°C
• Max. Water depth: 2m
Operation instruction
- Instructions for button and indicator
Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any
possible scratches to the pool.
Switch
Here is the shutdown state. Push switch to ON and the blue light will
always be on.
Indicator
Charging
Port
Nº
INSTRUCTIONS
INSTRUCTIONS.
FUNCTION DESCRIPTION
1
Switch
• Push the switch to ON, the cleaner starts running. Push
the switch to OFF, then the cleaner stop running.
2
Indicator
• Blue light is steady on: switch on
• Blue light flashes: the cleaner is working
• Yellow light flashes: low battery and self-beaching
• Yellow light is steady on: finish self-beaching
• Red light is steady on: switch off
• Red light flashes: faults
Fault handling: When red light flashes, please switch off and charge it, then put it into the pool again
and switch on. If the cleaner cannot get back to normal, please contact after-sales.
EN
