Badu Tec Badu Hydrostar 11, Инструкция по установке и эксплуатации

Страница: 36 / 71

35
3 mm for each contact. The pump has been designed in accordance with pro-
tection system I. The environmental temperature must never exceed 40°C. For
pumps with three-phase motors a properly adjusted motor cutout switch must
be installed. Please refer to motor nameplate. Failure to do this will void the
guarantee in case of motor failure. Pumps with A.C. motors should be provided
with an overload switch.
Caution ! The use of pumps for swimming pools and the restricted area
around them is only permitted if pumps are installed in accordance with
DIN/VDE 0100 Part 702. Please, consult your licensed electrician !
The supply circuit has to be protected with a fault current contactor with a
nominal fault current of I
∆ N
≤
30 mA.
For single-phase motors (1~), a power supply of minimally 3 x 1,5 mm
2
H07
RN-F or equivalent must be provided for.
Opening the terminal box cover with BADU Hydrostar 11, 15
D 90.212
6. Initial Startup
6.1
Unscrew the transparent strainer lid anticlockwise (if necessary use the span-
ner supplied), slowly fill the pump with clean water until the water level reaches
the inlet connection. Ensure the lid O-ring (412.1) as well as the sealing surface
on the lid is clean. Close the strainer lid (160) clockwise until it is properly
closed. If the lid is not properly closed the pump will not prime correctly or may
not prime at all.
Do not allow the pump to run dry, not even if only to check the direction
of rotation.
6.2
The pump must never be operated without the strainer basket (143), or the
strainer basket handle (otherwise the strainer basket will float upward) in order
to avoid clogging or blocking.
CAUTION
CAUTION