Badger Meter ModMAG M2000, Инструкция по установке и эксплуатации

Страница: 17 / 48

Programming Page 15/44
MID_M2000_BA_02_1004
5.2 Main menu
The following menu items are available to you in the main menu:
•
Meter setup
•
Measuring
•
Inputs and outputs
•
Reset of the totalizer
•
Setting of communication port
•
Specific counter settings
•
Counter information
•
Language selection
5.2.1
Meter Setup
Scale Factor Changing the scale factor lets you adjust the meter’s accuracy without
disturbing parameters set by the factory. You can tune the meter to
meet changing application requirements.
Empty Pipe
Detection Fluid monitoring shows if measuring pipe has only partly been
filled with liquid. Monitoring can be switched on or off.
Note: On request, fluid monitoring can be adjusted to fluid’s
conductivity or to cable length.
Power Line
Frequency For an optimum operation of the meter, set Power Line Frequency in
this menu at operating location.
Excitation
Frequency This value shows in which frequency the meter’s coils are operated.
Supported frequencies are dependent on the configured power line
frequency and meter’s size.
Note: When selecting excitation frequency, make sure to always
observe that the ratio in respect of power frequency is integer.
50 Hz 60 Hz
1 Hz 1 Hz
3.125 Hz 3.75 Hz
6.25 Hz 7.5 Hz
12.5 Hz 15 Hz