Cable connections
Page 6 / 23
MID_VD_BA_02_1607
M
1
0
0
0
-2
3
M
10
00
-24
Harness connections
1. Clip the alligator clip labeled "Detector Ground" to either of the hex nuts mounted
on top of the meter flanges.
2. Plug the connector labeled "Amplifier Electrode" into the circuit board connector
labeled "E1, ES, E2, ES, EP".
3. Plug the "Amplifier Coil Output" into the circuit board connector labeled "CS, C2,
C1."
4. Plug the "Output 1 & 2/ Input" into the board output connector labeled "1 to 6."
5. Plug the “Analog Output" into the board output connector labeled "9 to 8".
6. Plug the "RS232" connector into the board connector labeled "ABZYG".
7. Connect the harness wire connector labeled "Detector Electrode" to the 5-wire
connector from the detector.
8. Connect the harness wire connector labeled "Detector Coil" to the 3-wire connector
from the detector.
Amplifier coil
Amplifier electrode
Output 1 & 2 / Input
Analogue output
RS232
Detector electrode
Detector coil
Detector ground