Badger Meter Impeller 228PV150U Series, Руководство пользователя

Страница: 11 / 16

Programming
Page 11 March 2017 SEN-UM-01662-EN-05
6 . Click
Poll Now
to update the current values .
7 . Select Configuration > Parameters to open the Parameters screen . You can also select the Parameters button . See
Figure 14 .
Figure 14: Select Parameters
8 . Program the wireless receiver using the Parameters screen in Figure 15 as a reference .
a. Serial Number
: Enter the serial number of the
wireless receiver . ‘
b. Volume Unit : Select the desired volume unit for scaled
output pulses .
c. 1 Pulse
: Enter the desired volume per scaled
output pulse .
d. Pulse Width : Enter the scaled output pulse width .
OTEE: N The default pulse width is 50 milliseconds .
Minor variation in pulse width may be
required, depending on controller interface .
e. Lost Signal Recovery
: Configure this section
depending on the application requirements . If
checked, the data accumulated during a lost signal
period will be recovered . See the instructions on the
screen for more information .
f. Send : Click to calibrate the wireless receiver with the
information that was entered .
g. Refresh
: Click to see the current programming .
h. Defaults : Click to enter the factory default
programming .
OTEE: N Selecting Defaults overwrites all settings .
i. Exit
: Click to exit and close the Parameters screen .
Figure 15: Receiver parameters
9 . Click the
X
in the top right corner of the screen to exit the programming software .