5
Batch (Auto) Mode
1. Program the meter to auto mode using option 1-6 in
the batch-programming mode. (See Programming the
Batch Function)
2. Pull the trigger to begin the flow. The valve will
automatically lock in place, even though the trigger will
fall back to the closed position. The flow will
automatically shut off when the desired batch size has
been dispensed.
The valve will always lock in the maximum open position.
Note: At any time during the operation of the meter, the
flow may be stopped by pressing the red
button.
This will mechanically close the valve, stopping the flow.
Batching may be resumed by pulling the trigger.
3. The user has the option to top off at the end of the batch.
To top off the tank, simply pull the trigger to begin the flow
and release when the desired amount has been
pumped. If in count down mode the additional amount
will be shown on the display. If in count up mode, the
additional amount will be added to the total amount
dispensed.
4. Press the
button when finished to reset the
meter. It is now ready for the next batch.
Do NOT press
before topping off. The meter will
begin a new batch.
Normal Operating Mode Functions
History
This option allows the user to review the previous five
batches dispensed with meter.
1. Press and hold the
/ HISTORY button to view the
five previous batches. The batches will be displayed on
the screen one at a time, starting with the most recent,
and cycling through to the oldest. The batches will
continue cycling as long as the HISTORY button is held
down.
The display will automatically return to the normal
operating screen 2 seconds after releasing the
HISTORY button.
QT
HISTORY
HISTORY
..
History Function
Note: The history cannot be erased, unless the user
changes from English units to metric units or from metric to
English units. (See Changing Factory Settings.)
Flow Rate
This option allows the user to see the instantaneous rate
at which oil is flowing through the meter.
While oil is flowing through the meter, press and hold the
/ FLOW RATE button, and the rate of flow will
appear in the bottom right corner of the display. As long
as the button is held down, the flow rate will remain on
the display. Releasing the button will return the display to
the normal operating screen.
QT
,,
GPM
GPM
GPM
.
Flow Rate Function
Note: The flow rate can only be displayed if fluid is flowing
through the meter.
Total
This option allows users to see the accumulated total as
well as the resettable total.
Press and hold the
button while in normal
operating mode to see the accumulated total. Continue
holding and after three seconds the screen will change to
the resettable total, which displays the total fluid
dispensed since the resettable total was last set back to
zero.
Press the
button while viewing the resettable total
to set the resettable total back to zero. Release the
button to return to the normal operating screen.
Note: The accumulated total cannot be reset, unless the
user changes from English units to metric units or from
metric to English units. (See Changing Factory Settings.)
L
RESET TOTAL
Total Function
