The indication of irrelevant parameters can be turned off Also, parameters that are not relevant to the set meter configuration
will not be indicated
The indication of parameters can be turned on or off by means of the configuration programme HEAT3-SERVICE through
the optical interface when installing the meter (if the meter is in the transport mode) or connecting the jumper SERVICE at
any time
Viewing Calculator Readings in Test Mode
The diagram of the review of calculator readings in the
Test Mode
is shown in
Figure 3: The diagram of the review of electronic unit readings in the Test Mode.
Display readings in the Test Mode
ID
Parameter
Value
Notes
4 1
High resolution energy
TEST
000000 00
Wh
Updated every second
Indicated as “Pulse Wh”, if the energy test
pulse output is activated (“Pulse m
”“3”
– in
the case of volume pulse output)
TEST
PULSE
Wh
4 2
High resolution integrated
volume
TEST m³
00 000000
Updated every second
Indicated as “Pulse Wh”, if the energy test
pulse output is activated (“Pulse m
”“3”
– in
the case of volume pulse output)
TEST
PULSE
Wh
4 3
Supply heat carrier
temperature value
1 TEST
0 0
°C
4 4
Return heat carrier
temperature value
2 TEST
0 0
°C
4 5
Temperature difference
1-2 TEST
0 00
°C
4 6
High resolution flow rate
1-2 TEST m³h
0 00
°C
Operating Procedure
Page 25
November 2020
HYB-UM-03193-EN-02
