3.0/0517/TG
NOTICE!
Proper maintenance of your Embassy™ chair will ensure
years of use and enjoyment. Retain these instructions and
review and follow them regularly.
Check and retighten all hardware 1-2 weeks after initial assembly.
Thereafter, check
to make sure all the
hardware remains tight at least on a monthly basis.
Loosen the hardware before adjusting height/position of the seat and footrest panels, or when you add/remove the
front bar or wood tray, to ensure you don’t damage the parts or wood finish. Be sure to retighten the hardware securely
after any adjustments.
Also, please level the chair when assembling for the first time and when making any adjustments. Level the chair
by standing it up on a flat, level floor/surface when the hardware is still slightly loose, and then tighten all the hardware
securely.
After initial assembly, keep the ALLEN WRENCH in a safe place!
Please note that if your table has a wide apron under the
table top it makes it easier for your child to push his/her
legs against the table and tilt backwards. For this reason,
you must ALWAYS use the Glide Extenders included with
the chair and ALWAYS supervise your child while in the
chair.
To prevent instability when your child is climbing in and
out of the chair, the front edge of the Foot Rest Platform
should NEVER stick out past the front edge of the chair
legs at floor level.
The Embassy™ chair is designed to
slide on the floor and remain in an
upright position, assuming a proper
floor surface is used. Always use the
Embassy™ High Chair on a level,
stable, hard floor surface that doesn’t
prevent it from gliding backwards. Soft
surfaces, such as rugs, carpets, and
foam padding or any surface the chair
can sink into, are not safe nor suitable
for the Embassy™ chair. Any uneven
surface, such as tiled floors, is also
unsuitable. The chair and glide extend-
ers and the floor must always be kept
clean.
