Badger Basket Elite 850, Инструкция по сборке, Страница: 3 / 5

1.0/0205
Page 3 of 5
STEP 3: See PICTURES 3A and 3B .
Turn the bassinet stand upside down.
Attach ONE CASTER WHEEL (F) to
EACH LEG of the bassinet stand using
ONE BOLT and ONE NUT for each
WHEEL.
Tighten each wheel securely using pliers if
necessary to turn the nuts. The BASSINET
STAND is now assembled.
STEP 4: See PICTURE 4 .
Locate the FOUR T-NUTS (G) and FOUR 1¼”
BOLTS (H) so you can bolt the OVAL BASSINET
BODY (I) to the BASSINET STAND.
This step is easiest to do if you put the oval
bassinet body upside down on the floor, and then put
the bassinet stand upside down on top of the bassinet
body as shown in
PICTURE 4 .
Line up the four holes on the stand with the four
holes on the body.
Insert the FOUR T-NUTS (G) into the four
holes on the TOP RAILS (C).
Then insert the FOUR 1¼” BOLTS (H) through
the four holes on the OVAL BASSINET BODY (I)
and securely screw them into the FOUR T-NUTS (G).
STEP 5: See PICTURE 5 .
With the bassinet in its correct, upright position,
wrap the FABRIC SKIRT (J) around the
LOWER rim of the OVAL BASSINET BODY
(I) pressing the grip tape strips together as you
go around
Begin at the rear center where the metal spindle
is located.
The ends of the skirt will meet at the starting point
and overlap.
J
I
C
C
PICTURE 4
PICTURE 5
F
F
F
F
PICTURE 3A
PICTURE 3B