20
helP
hints and tricks
maintenance
●
Paper Inlay
Our machines are generally laid out for the usage of 80-90g strong paper. Paper which is too
thick or too thin can cause problems. If you are not sure: Just try it out! This is also valid if you
want to use inlays consisting of any other material which you want to try instead of paper.
Pay attention that the (paper-)inlay has the right diameter (always exactly the same diameter
as the foil). A (paper-)inlay which is too small or too big might cause problems. Also pay
attention that the inlay is cut properly and round.
●
usage of Fabric
Experience shows that nearly every kind of fabric can be used for buttons. Exceptions are
very thick and unflexible fabrics, woolen fabrics or fabrics with a high share in stretch. But
there are so many kinds of fabric that it is hard to cover them all. If you are not sure if it
works: Just try it out! Instead of the paper inlay, just use the fabric cut in the right size and
leave out the foil!
●
transport
If you carry your badge maker, please regard that the two lower stamps are not tightened
on the swivelling plate. The lower stamps and also the upper stamp might fall down, cause
injury and get damaged. Also the upper stamp might fall down!
For transport and storage of the stamp set, the provided carton with foam material is most
suitable. The inner parts of the stamp sets are partially made of soft material and therefore
relatively damageable. Please also regard this if you exchange the stamp set or remove it for
any other reason. Always handle the stamp set (especially the upper stamp) with care!
●
a Few Drops of oil
The machine does not need much maintenance. But every badge maker should enjoy some
drops of oil from time to time. Sprinkle some drops of precision oil on the parts marked with
a little oil can (don`t exaggerate!). Leave out other parts of the machine as they might stick.
●
cleaning
Dust and remains of paper should be removed from the stamps regularly so that they
can not accumulate. Most suitable is to use a clean brush. Generally it will be good for the
machine if it is cleaned completely from time to time. Dust and dirt can accumulate and
cause malfunction of the machine. Use water, a wet cloth and a mild cleaner.
