background image

ADVERSE SOUNDS (continued) 
 

Shut down the amp and check the tubes. Wait for the amp to cool down. Remove the back panel 
of the amplifier. 

Avoid handling hot tubes as they can cause sever burns.

 Check the larger 

output power tubes first by carefully removing the tube shields or loosening the tube clamps, and 
then unseat the tubes from their sockets but note from which socket you removed the tubes. 
Inspect the integrity of the filaments in the tubes. If one or more of these tubes are bad, you will 
need to replace the entire set of the power tubes. If all the tubes are OK, you can eliminate the 
adverse sounds by swapping the location of these tubes. If this fails to fix the problem, you may 
need to replace the entire set of power tubes with a new matched set. Use of inferior quality 
(untested and no-rated) tubes may cause damage to your amplifier. 
 
You should also check the preamp tubes, especially the first input stage tube (far right if you’re 
looking at the amp from the back). Micro-phonics (feedback noise that cannot be controlled by 
turning down the volume pot on you guitar) indicates a bad preamp tube(s). You may want to 
swap the position of preamp tubes to see if this will fix the micro-phonics problem. Preamp tubes 
can go bad without warning but can also last many years without any problem whatsoever.  
 
As you can see when handling tubes, they are sensitive, fragile and somewhat prone to 
inconsistencies. Please handle your amp with care when transporting it. Although your Bad Cat 
amp is sturdily built and designed to take years of rugged use, the tubes are not. It’s always a 
good idea to keep extra tubes (both preamp and output power tubes) handy, especially for 
performance situations. An overwhelming majority of minor problems on tube amps are tube-
related and it’s just a matter of swapping one or more out to have your amp performing like 
brand new again.  

 
Limited Warranty 
 

Bad Cat amplifiers are guaranteed to be free of defective materials and workmanship for a period 
of 5 years from the purchase date to the original owner. This warranty, though, does not cover 
bulbs, vacuum tubes and loudspeakers, which are guaranteed for 90 days from date of purchase. 
This limited warranty does not cover abuse, drops, acts of God, mismatch of voltage applications 
or any application outside of guitar amplification, nor factory-unauthorized modifications. Only 
a Bad Cat authorized service center or dealer can perform repairs to maintain warranty validity. 
 
 

Bad Cat and all model names are trademarks of the Bad Cat Amplifier Company. Specifications are subject to change without notice. 
 
 
 
 
 

 
 
 
 
 
 
 
 

Содержание Hot Cat Series










Отзывы: