Rear Panel (from left to right)
Power Input
This is where you connect your power cable. Use IEC power cable only. The cable should only be
connected to a power outlet that is compatible with the voltage, power and frequency
requirements stated on the rear panel.
Power Switch
When engaged voltage is applied to all internal circuits except for the high voltage for all signal
amplifying audio stages.
Standby Switch
Applies the high voltage to all signal amplifying audio stages.
HT Fuse
The value of the HT Fuse is specified on the rear panel. Never use a fuse of the incorrect value or
attempt to bypass it.
Footswitch
The supplied 2-button footswitch is connected here. The footswitch enables you to switch
between Channel 1 or Channel 2 and LO or HI mode.
FX Loop Send
This jack sends a -10dB low impedance signal to your effects devices, regardless if it is pedals or
rack units. Use a shielded instrument cable.
NOTE: The internal Noise Gate is processing the signal right before the SEND output, so that the
trail of time based effects like delay or reverb decay naturally and are unaffected.
FX Loop Return
High Impedance input to the recovery stage of the FX Loop and a direct input to the power amp.
This jack disconnects the preamp signal from the power amp when used in case you want to
utilize the power amp only. Plug a shielded instrument cable into this jack and connect to the
effects.
NOTE: Signals applied will not be processed by the internal Noise Gate
Speaker Outputs
There are overall 5 speaker outputs, 1x 16
Ω
, 2x 4
Ω
and 2x 8
Ω
. Both 4
Ω
as well as both 8
Ω
are
wired in parallel. In case you want to use two cabinets at the same time, 2x 16
Ω
cabinets should
be connected to the two 8
Ω
jacks, 2x 8
Ω
cabinets should be connected to the two 4
Ω
jacks.
NOTE: Always be sure that your amplifier is connected to a proper load or a speaker cabinet
before the amplifier is switched on.
Line Out
Non frequency compensated output with a tenth of the output level to drive post effects or
external power amps when running a wet/dry system or a speaker simulation device such as IR
loaders.
Содержание Cub
Страница 7: ...Cub Tube Chart...
