Bad Boy Onslaught 550 EFI 4X4 EPS, Руководство пользователя, Страница: 28 / 67

27
1. Place the ATV on a level surface. Turn the key to the OFF position and remove it from the
vehicle.
2. Remove front cover.
3. Place a container under the engine and then remove the coolant drain bolt and its gasket.
4. Remove the radiator cap.
5. Remove reservoir cap.
6. Disconnect the coolant reservoir hose on the coolant reservoir side and allow the coolant
to drain from the coolant reservoir.
7. After draining the coolant, thoroughly flush the cooling system with clean tap water.
8. Install the coolant drain bolt and its new gasket and then tighten the bolt.
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the reservoir to the maximum level mark and then
install the reservoir cap.
CAUTION!
Mix antifreeze with distilled water only. However, if distilled water is not available, soft
water may be used for refilling. Do not use hard water since it is harmful to the engine.
11. Pour the recommended coolant into the radiator until it is full.
Antifreeze/water mixture ratio:
1:1
Recommended antifreeze:
High quality ethylene glycol antifreeze containing corrosion inhibitors for aluminum
engines.
Coolant quantity:
Radiator capacity (including all routes): 2.3 quarts (2.2 L)
Reservoir capacity (up to the maximum level mark): 1.25 quarts (1.2 L)
12. Install the radiator cap, start the engine let it idle for several minutes and then turn it off.
13. Remove the radiator cap to check the coolant level in the radiator. If it is low, add sufficient
coolant until it reaches the top of the radiator and then install the radiator cap.
14. Start the engine and then check for coolant leakage.
15. Install the front cover.
16. Remove key.