11
11
ASSEMBLY INSTRUCTIONS
11
12
11
Connect the hose to the hose connector in the control box.
. Propane Only-Proper Hose Connection.
WARNING!
Ensure the hose does not contact any high
temperature surfaces, or it may melt and leak causing
a
Always test the hose and connections for leak with soapy
water at the end of all connections.
fire.
12. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal
supply system. See chapter 12 of the standard for
storage and handling of liquefied petroleum gas,
ANSI/NFPA 58. Your local library or fire department
should have this book.
A minimum supply pressure of 0.4 p.s.i. is required for
the purpose of input adjustment for propane gas.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated area out of the reach of children. A
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage
or any other enclosed area. The minimum permissible
gas supply pressure of 10 W.C. is required for purpose
of input adjustment. The minimum hourly of 17000 Btu
is required input rating for a heater for automatic
operation at ratings less than full input rating. The
pressure regulator and hose assembly supplied with
the appliance must be used. The installation must
conform with local codes, or in the absence of local
codes,with national fuel gas code, ANSI Z223.1
/NFPA54, natural gas and propane Installation Code,
CSA B149.1, or propane storage and handling code,
B149.2.
Standard 20 lb. tank
ASSEMBLY INSTRUCTIONS
WARNING! Ensure the hose does not contact
any high temperature surfaces, or it may melt
and leak causing a fire. Always test the hose
and connections for leak with soapy water at
the end of all connections.
11.
Propane Only-Proper Hose Connection. Connect
the hose to the hose connector in the control box.
12. Connect hose and regulator to cylinder. The
propane gas and cylinder are sold separately. Use
a standard 20 lb. propane cylinder only. Use this
heater only with a propane vapor withdrawal
supply system. See chapter 12 of the standard
for storage and handling of liquefied petroleum
gas, ANSI/NFPA 58. Your local library or fire
department should have this book. A minimum
supply pressure of 0.4 psi is required for the
purpose of input adjustment for propane gas.
Storage of an appliance indoors is permissible
only if the cylinder is disconnected and removed
from the appliance. A cylinder must be stored
outdoors in a well-ventilated area out of the
reach of children. A disconnected cylinder must
have dust caps tightly installed and must not be
stored in a building, garage or any other enclosed
area. The minimum permissible gas supply
pressure of 10 W.C. is required for purpose of
input adjustment. The minimum hourly of 17000
BTU is required input rating for a heater for
automatic operation at ratings less than full input
rating. The pressure regulator and hose assembly
supplied with the appliance must be used. The
installation must conform with local codes, or
in the absence of local codes, with national
fuel gas code, ANSI Z223.1/NFPA54, natural gas
