Assembly Tip:
• If during assembly of beams the
threads do not engage, install the
bolt without the star washer to seat.
Once seated loosen, add washer,
and re-tighten.
Pergola Assembly
IMPORTANT ASSEMBLY TIPS
Assembly Tip:
• To ease assembly and to reduce the
chance of splintering the beams,
lightly sand the leading edges of all
the notches using sandpaper.
• To reduce friction during assembly
apply bar soap to the surfaces of the
notches where shown.
Apply bar soap
to both sides.
Additional Assembly Tips:
• If it is necessary to pound on the beams using a hammer or rubber mallet, be sure to place a scrap of lumber
between the hammer and the beams. This will help to ensure the beam is not damaged.
• Lag screws may be used to pull together upper and lower beam assemblies.
NOTE: PROPER NOTCH ALIGNMENT MUST BE MADE TO ENSURE NO DAMAGE OCCURS
TO BEAMS.
Assembly Tip:
• If during assembly the holes in the
beams and plates do not align you
may need to drill them using a 3/8"
drill bit for better fit.
