Backyard Discovery 2304079, Руководство пользователя, Страница: 150 / 170

Prepare the Gas Supply
1. Open the hood completely. Do not light burners with the
hood closed.
2. Make sure control knobs are turned to OFF. The drip tray
must be in place and pushed all the way to the
back.
3. Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds.
4. After a period of non-use, before lighting the sear burner,
a few seconds must pass for the gas supply line to fill.
5. When using the snap igniter you will see a flash of flames
moving from left to right across the sear burner surface.
The sear burner is not lit until the entire ceramic surface is
aflame.
6. Push the control knob in and turn it to the + position.
Using other hand, push electric igniter control knob at the
same time to generate spark and to light sear burner.
Continue to hold the control knob down for twenty
seconds after the burner has ignited.
7. Release control knob.
8. Check that the sear burner is lit by the red glow across
the entire surface of ceramic.
Caution: Sear burner flame may be difficult to see on a bright sunny day.
Warning: If the sear burner does not light, turn the burner control knob
to the OFF position and wait five minutes to let the gas clear before you
try again or to try and light manually with match.
Fire Hazard
!
!
WARNING
Sear Burner Ignition
Manually Lighting the Rotisserie
1. Do not lean over the grill.
2. Open the lid.
3. Remove the manual lighting extension from underneath
grill cabinet, attached to upright tube ( see following
illustration) and attach a match to the split ring.
4. With match attached to split ring, strike match.
5. Hold the matchstick holder with lit match by right side of
rotisserie burner.
6. Push the control knob in and turn it to the + position . Insert
match holder and lit match down through cooking grates to
ignite the sear burner. Continue to hold the control knob
down for twenty seconds after the burner has ignited.
7. Release control knob.
8. Check that the sear burner is lit by the red glow across the
entire surface of ceramic.
TO EXTINGUISH:
Push in and turn each burner control knob clockwise to OFF
position. Turn gas supply off at source when finished.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the "Assistance" section.
Warning (After use):
Storage of an outdoor cooking gas appliance indoors is permissible
only if:
The cylinder is disconnected and removed from the outdoor
cooking gas appliance.
TO EXTINGUISH:
Push in and turn each burner control knob clockwise to OFF
position. Turn gas supply off at source when finished.
23