Step 4:
Hand tighten 2-3 turns only.
Hand tighten 2-3 turns only.
Attention : Positions 1 and 2 are the different heights you can choose from to place the shelf on. There is a bracket in position 2 where you can put the shelf up (when not in use)
or down (when in use).
Attach the shelf to the two legs by using the 1/4"x45 mm bolts and Ø12.5x3 mm washers bolts and washers as shown in the
.
Insert a
1/4"x18 mm bolt into table leg-1 as shown in the
Attach the bracket to the back frame by using the 1/4"x15 mm bolts and Ø15x2 mm washers bolts and washers as
shown in the
.
F
3a
F
3b.
F
3c
igure
igure
igure
J
G
F
Figure 3a
Figure 3c
D
L
M
1
2
Step 5:
Note:
Do not over
tighten
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to tighten all nuts and bolts.
each bolt and nut must be tightened
a few revolutions at a time. In order to apply equal pressure to all bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts. Cover all bolts with bolt covers.
Step 6:
With the help of another person, turn the table in the upright position. Your table is now ready for use. If you have any questions, please call our Customer Service Center at
1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under our warranty. Please read all instructions
carefully before assembly. If you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.
Figure 3b
AME03229K01
Page 3
