Figure 1
Figure 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD, AND RECEIPT.
Page 2
PARTS LIST
DESCRIPTION
ORDER PART # QTY
1
A
B
C
D
E
F
G
1
HW0004
HW0006
FOOT CAP
FACTORY ASSEMBLY
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
Ø6.5 X 1.0 MM
WASHER
FC0007
Step 1:
Do not attempt
assembly if any parts are missing or damaged.
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify the parts packed in the
carton against the parts list. If you are missing any parts or
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511.
Step 2:
Hand tighten only
2-3 turns.
Attach a table leg to the table top by using two
1/4"x20mm bolts and washers as shown in
.
Guide the bolts through the holes in the leg into the
pre-drilled holes in the
.
Repeat for the other leg.
F
1
Place the table top upside down on a flat, non-abrasive
surface.
table top
igure
Step 3:
Attach the leg connector bracket to the two legs to by
using the four 1/4"x35mm bolts and washers as shown
in
. Guide the bolts through the holes in the
leg connector bracket,
legs.
F
2
into the pre-drilled holes in the
Hand tighten only 2-3 turns.
igure
8
2
1/4" X 35 MM BOLT
HW0142
4
1
B
FOOT CAP
C
A
1/4" X 20 MM BOLT
HW0036
4
E
F
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE TOP
HEX BOLT DRIVER
S3-AGT12420K01
D
F
Step 4:
Note:
Do not over tighten
After making any necessary adjustments to the
alignment of the table, use the hex bolt driver to
tighten all bolts.
each bolt must be tightened a
few revolutions at a time. In order to apply equal
pressure to all bolt joints, we recommend working in a
cross corner (X fashion). Repeat until all bolts are tight.
. Over tightening may strip bolts.
With the help of another person, turn the table in the
upright position. Your table is now ready for use. If you
have any questions, please call our Customer Service
Center at 1-800-416-3511.
Step 5:
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your
assembly, call our Customer Service Center at 1-800-416-3511.
AT53129
AT53130
AT53131
