4
U
SING
Y
OUR
S
MOOTHIE
S
WIRL
™
C
ONTROL
B
UTTONS
:
“PULSE” - gives short bursts of power at high speed. Use
“PULSE” to begin the mixing of ice and other hard
ingredients.
“ON” - runs the unit continuously. Use this speed for final
stages of mixing and dispensing.
“OFF” - turns off the appliance.
To make your favorite frozen drinks, follow the steps below.
1. ASSEMBLE –
•
Position the rubber gasket down onto the circular flat surface in the blade
base.
•
Screw blade base on the bottom of the blending jar by twisting the blade
base counter-clockwise until tightened. Make sure that the blade base is
tightly fastened to the blending jar and that the rubber gasket is properly
compressed between the blending jar and the blade base.
•
Push the lid onto the top of the blending jar. Lock the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
•
Place the blending jar onto the motor base so that the bottom of the blade
base is sitting flat on the motor base.
•
Plug the cord into a 120 volt, AC outlet only.
2. ADD LIQUIDS – Add any combination of liquid ingredients up to the “LIQUIDS”
mark under “SERVES 3” located on the blending jar. Liquids include any soft
ingredients such as fruit, milk, fruit juice, herbal supplements, or yogurt.
3. ADD ICE – Add ice or frozen ingredients until the total level reaches the
“FROZEN INGREDIENTS” line on the side of the blending jar. Frozen
ingredients include ice, frozen fruit, frozen yogurt, ice cream, etc.
4. SMOOTH IT – With the lid on and the stir stick (use as directed below) set in the
hole in the lid, pulse the mixture 2 or 3 times by pressing the
“PULSE” button. Then press the button to “ON” and wait until
the ingredients are completely mixed. Do not blend for longer
than 3 minutes.
STIR STICK OPERATION – When in use and while the
machine is running, stir or rotate the Stir Stick in a counter-
clockwise direction so that the Stir Stick scrapes or contacts
the sides of the blending jar. This stirring operation will force
the ingredients into the mixing blades.
5. SERVE IT – To serve the smoothie, press the switch to “ON,”
place a cup under the valve and press down the valve lever.
Stir the contents in the blending jar with the stir stick while dispensing thick
smoothies. As the smoothie level reaches the bottom of the blending jar, a thick
mix may stop dispensing. Add a few tablespoons of liquid to increase flow.
When the blending jar is empty, turn the machine “OFF.” You can continue
making smoothies one after another, but be sure to give the smoothie maker a
5-minute break after 3 minutes of continuous use.
•
To make a thicker smoothie, add more frozen ingredients.
•
To make a thinner smoothie, add more liquid ingredients.
