Bacharach Portable Wireless Infrared Printer, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 16

Instruction 24-9450 6
Operation IrDA Printer
Set-Up Mode
The printer has been set up at the factory with the following default
parameters:
Column : 32 column
Baud rate : 9600 bps
Handshaking : DTR
Country : U.S.A.
Print mode : Text (upright)
Paper : Normal paper
Density : 100%
IrDA : IrDA-SIR
If necessary, the default parameters can be changed as follows:
1. With the printer initially switched OFF, press and hold down the SEL
pushbutton, and then switch ON the printer.
2. The printer now goes into its set-up mode as indicated by the red LED
flashing. At this time all of the printer’s current parameter settings are
printed, followed by the first parameter that can be modified.
Note: If no button is pressed within 15 seconds, the set-up
mode is automatically terminated without changing the
original parameters.
3. Column is first parameter printed. Pressing the FEED button causes
the value of that parameter to change in the sequence shown in the fol-
lowing table.
SEL Button FEED Button
Column 32, 36
Baud rate 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200
600, 300
Handshaking DTR, X-on/X-off
Country U.S.A., Turkish, Denmark2, Norway, Japan, Spain,
Italy, Sweden, Denmark1, U.K., Germany, France
Print mode Text(upright), Data(inverted)
Paper Normal paper, Reprint paper
Density 50 – 150% in 5% steps
IrDA HP-Ir, IrDA-Off , IrDA-Sir, BHT-Ir(DENSO), ELME-Ir,
CHAMJIN-Ir, IrDA 1.0