Babyviewer RA-4500, Руководство пользователя, Страница: 11 / 20

user manual
11
Babyviewer RA-4500
Baby phone mode.
The Babyviewer can also be used as a audio babyphone, this is an option to save energy. Follow the
procedure below.
• Make sure the VOX mode is off, see the VOX paragraph for instructions
(See “10.13 Voice activated transmission (VOX)”).
• Press the on/off button
25
to go to audio babyphone modus.
• Press the on/off button
25
again to turn on the display again.
Checking the connection between the parent unit and the baby unit
You should always check the wireless connection when you use the babyphone for the first time.
• Put the parent unit in the same room as the baby unit, separated by at least two meters.
Switch on both devices. The parent unit will try to establish a connection with the baby unit.
• The display of the parent unit will show the captured image from the baby unit after the connection
has been established (monitor mode).
• The sounds picked up by the microphone
6
are reproduced by the parent unit.
• The volume of the reproduced sound is indicated by the volume LED’s 14 at the top of the parent
unit. The higher the volume, the more LED’s are on.
• If no connection is established, “OUT OF RANGE” is displayed.
Out of range indication
The maximum range between the parent- and baby unit is 300 meter in open area. Different factors,
such as bricks and plaster walls, will reduce the range. Moreover, reinforced concrete floors will
influence the range tremendously.
In a residence, normal operating range is up to 50 meters and 2 floors.
• If the connection is interrupted, “OUT OF RANGE” is displayed.
• Reduce the distance between the parent and baby units until a new connection is established.
Setting the reproduction volume of the parent unit
There are 5 volume levels.
• Press button
16
to increase the volume.
• Press button
17
to decrease the volume.
Setting the parent unit display brightness
When the display in on.
• Press the menu button
23
once. The Brightness icon is displayed.
• Press the up 16 or down button 17 to select the desired brightness (5 steps).
• Press the menu button 23 to confirm.
• After 10 seconds the parent unit will switch back to monitor mode.
RA-4500_usermanual Jan 2014.indd 11 21/01/2014 11:53 am