CRIB ASSEMBLY INSTRUCTIONS
Step 1: To begin, you will need the Right and Left Side
Frames, two caps, two M8*80mm Flat Head
Bolts, four M8*25mm Round Head Bolts,
four M8 Metal Washers and the Back
Frame Assembly. Attach one
cap to the highest part of
the top rail of the Right
Side Frame and align the
frame to the Back Frame
Assembly making sure the
top rail is aligned with the top
hole of the Back Frame. You
will attach the Right Side
Frame with the cap to the Back
Frame Assembly using a
M8*80 mm Flat Head Bolts by
sliding the bolt thru the top
pre-dilled
hole of the
Back Frame. Then,
you will slide two M8*25mm
Round Head Bolts and two
washers thru the bottom hole. Now,
using your Allen Wrench tighten all the
bolts at this time. ***Repeat the steps for the
Left Side Frame.
Next, you will need to attach the Front Frame. For this step,
you will need the Front Frame Assembly, four M8*25mm
Round Head Bolts, and four M8 Metal Washers. First, remove
the protection caps at the end of the Right Side Frame using
the Allen Wrench. Then, attach the Front Frame to the Right
Side Frame using two M8*25mm bolts and two M8 Metal
Washers. Slide the bolts thru the two bottom pre-drilled holes
on the Right Side Frame post into the inserts of the bottom
post of the Front Frame Assembly. Next, slide an M8*100mm
Flat Head Bolt into the hole in the ball on the top of the Front
Frame Assembly into the nut of the Right Frame top rail end.
Now using your Allen Wrench tighten all the bolts at this time.
***Repeat the steps for the Left Side Frame.
In this step, you will attach the Mattress Support by using four
M6*15mm Round Head Bolts and four M6 metal washers,
and the Allen Wrench. Swing the support arms out on the
Mattress Support and place them in the against the desired
Mattress Support holes level. Slide the bolts with the washers
thru the Mattress Support arm into the Back Frame and Front
Frame post holes. Tighten all the bolts at this time using the
Allen Wrench.
Step 2:
Step 3:
Содержание Cirque Crib
Страница 4: ...REV 12 14 ...
