10. Place walker on a solid flat surface with bottom of base facing upward. Insert the
pins of the wheels into their housing, pressing them until they snap into position.
Please check that wheels are locked into place as figure 9 and figure 10.
Figure 9
Figure 10
11. Turn base up side down, insert the strips properly with middle post and the both
side post as figure 11. Be sure the strips attached to the bas securely before in use.
Figure 11
14. The baby walker can be used for 3 different heights. To adjust heights, remove
baby from walker. Turn the safety button lengthwise and press the safety button until
the mechanism is released. Adjust to desired height as shown in figure 12.
Figure 12
15. When the position has been selected, check that the safety button turned through
90 degrees to prevent the accidental release of the mechanism as shown in figure 13.
Always follow this procedure. Never use the baby walker if the button is not in the
sideways position. Important: Never change the height when the baby is in the walker.