6. If the charging light starts to flash rapidly (more than 4 flashes per second) then the
appliance is faulty. If this happens then please stop charging and remove the adapter
from the mains and contact an authorized Service Center.
WARNING:
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to operate the
equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by Conair LLC, the
manufacturer of this product and the party responsible for compliance, could void the
user’s authority to operate the equipment.
FOR DIRECT PLUG-IN OPERATION
Make sure clipper is off. Connect charging jack into the receptacle at the end of clipper
and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to ON (marked ""). To stop operation, set to the OFF
(marked " ") position.
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
USER MAINTENANCE INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure maximum cutting
performance and proper maintenance. Hold the clipper away from your body in a
downward position, and apply a drop of BabylissPro lubricating oil on the front and
sides of the cutter blade. Wipe off excess oil with a soft, dry cloth.
Do not pull, twist, or wrap the supply cord around the appliance.
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, turn the clipper to “ ” position. Slide the
comb attachment onto the top of the clipper blade, and then pull down and
over the back of the blade. To remove, pull up on the back of the comb
attachment and then pull away from the blade.
FX870 BOOST+ IB-00000.indd 5-6
FX870 BOOST+ IB-00000.indd 5-6
2022/8/22 10:32 AM
2022/8/22 10:32 AM
