BaBylissPro FOILFX 02 BFS2GA, Руководство по эксплуатации

Страница: 3 / 6

CAUTION:
• DO NOT run shaver or cutters under
water. Use only the small brush (included)
to clean.
• To clean the external surfaces of the
shaver, use a damp cloth. Do not use
strong detergents or other chemicals.
• To dry, wipe the surface of the shaver
with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
• The shaver should not be used until it has
completely dried.
• Be sure voltage is correct before plugging
in. For connection to power supply not
in Australia abroad use an attachment
plug adapter of the proper configuration
for power outlet. The included adapter
automatically adjusts to the input voltage.
DO NOT USE A VOLTAGE CONVERTER .
TO REPLACE FOIL HEAD ASSEMBLY
1. Remove the foil head assembly by
pressing the round release button
located on the side of the shaver. Hold
the foil head assembly on both sides and
lightly pull away from shaver unit.
2. Take the replacement foil head
assembly (FXRF2) out of package. Align
the replacement foil head assembly
over the cutters. Carefully move the
replacement foil head assembly down
towards the shaver unit until it firmly
snaps into place.
BE CAREFUL NOT
TO DAMAGE THE FOILS OR CUTTERS
WHILE INSTALLING
.
BATTERY REMOVAL
This shaver contains Ni-MH batteries.
To help protect our environment, the
lithium-ion batteries should be removed for
safe disposal at the end of the shaver’s life.
Please take the appliance to a recycling
center, where the internal rechargeable
battery should be removed and recycled
separately.
For more information about recycling of
electrical and battery operated appliance,
please contact your local office or your
household waste disposal service.
TO REPLACE CUTTERS
NOTE:
Always replace the cutters and foil
head assembly at the same time.
1. To remove cutters, place your fingers on
each side and gently pull up and away
from drive shaft.
2. To replace cutters, remove the new
cutters from their packaging. Align cutter
about the drive shaft and lightly push
down until it snaps into place.
3. Replace the foil head assembly, turn
shaver on to ensure it is working
properly.
DAILY MAINTENANCE:
1. Press the release button on the sides of
shaver and remove the head assembly
(see Fig. 1 & 2).
2. Use cleaning brush to whisk away any
debris on and around cutter (See Fig. 3).
3. Snap the head assembly closed (see
Fig. 4).
WEEKLY MAINTENANCE:
1. Repeat steps 1 – 3 from the Daily
Maintenance cleaning steps.
2. Rinse the head of the shaver under
running water (see Fig. 5). NEVER
submerge the shaver in water.
3. Leave head open for drying.
4. Press the shaver head back into place
(see Fig. 4).
GOOD
BAD
BENT
Fig.
1
Fig.
2
Fig.
3
Fig.
4
Fig.
5
Washable
4 5