INSTRUCTIONS FOR USE
• Ensure the hair is dry and combed through to remove any tangles.
Divide hair into sections ready for styling.
• Press the button marked ‘I/0’ to turn the appliance on.
• Press the ‘+/-’ button to select the suitable heat setting for your hair
type.
• The appliance will heat up in seconds, the LED light will flash until the
heat setting has been reached. Allow slightly longer if using on the
higher temperature settings.
Please note:
Before styling make sure the universal heat glove is
worn on the hand which is wrapping the hair around the barrel.
• Take a section of hair, starting 2 inches from the scalp, wind the hair
section around the barrel until you reach the ends of the hair, ensure
the tip of the appliance is pointing downwards.
• Hold the ends of the hair for 5-8 seconds, depending on hair type.
Then unwind or release the section of hair and pull the appliance
away.
• Allow the wave to cool before styling.
• Repeat for each hair section.
• After use, press the ‘I/0’ button to switch off and unplug the appliance.
• Allow to cool before storing away.
Heat Settings
If you have delicate, fine or coloured hair, use the lower heat settings.
For thicker hair, use the higher heat settings.
It is suggested to always complete a test on initial use to ensure the
correct temperature is used on the hair type. Start on the lowest
setting and increase the temperature until desired result is achieved.
There are 5 temperature settings to select from 210°C, 195°C, 180°C,
165°C and Power (150°C).
