POWER SCREW
The power screw permits you to adjust the power of your
clipper. You may find it necessary to adjust it if the power in
your salon is low.
1. With screwdriver or coin, turn the power screw clockwise
until armature strikes the coil making a clacking noise.
2. Then turn the screw counterclockwise, just until the noise
stops. This is the maximum power setting.
ADJUSTABLE TAPER LEVER
The taper lever is positioned at your thumb. You can hold
the clipper in your hand and adjust the lever at the same
time – while you are clipping.
The taper lever adjusts the closeness of the cut from
a close cut with the taper lever in the up position, to
a longer length cut with the taper lever in the down
position. To increase cutting length, slowly push the lever down. To cut closer, push
the lever up. As different cutting edges are used in each setting, using the taper lever
lengthens the life of the clipper blades.
Too much hair can slow down hair clippers. Keep the clipper on for removing hair but
not the blades. Then push the taper lever back and forth quickly for several times. If
you do this every time, especially after much hair cutting, the clipper blades should
remain free of cut hair. Oil the blades after the above procedures.
Everyone knows that electricity and water are a dangerous
combination. But did you know that an electrical appliance is
still electrically live even if the switch is off? If the plug is in, the
power is on. So when you are not using the appliances, keep
them unplugged.
ALWAyS UNPLUG SMALL
APPLIANCES WHEN NOT USING.
WARNING:
IF yOU THINK THE POWER IS OFF
WHEN THE SWITCH IS OFF,
yOU’RE WRONG.
KEEP AWAY FROM WATER
BLADE SHARPENING (MODEL BAB604)
BabylissPro cutting blades are ground from the finest quality steel with carbon and
are hardened to extend the cutting performance. As with any cutting appliance, the
cutting edges become dull from repeated usage. Increasing blade tension to force the
blade cutting that would cause the clipper to overheat and reduce its motor life. When
the blade is no longer to cut smoothly, sharpening is required or replace it with new
BabylissPro blade set (model BAB604).
BAB850C IB-11_632B.indd 9-10
1/28/15 2:31 PM
