Babyauto Nico LB 513, Инструкция по эксплуатации

Страница: 15 / 18

23
www.babyauto.com
Tightening the harness
1. Pull the harness straps up to remove the slack from the lap section
of the harness, then pull the harness regulating strap until the
harness is fully stretched (5.10).
2. The harness should be as tight as possible without causing
discomfort to your child.
3. Make sure the lap section of the harness is positioned as low as
possible, surrounding your child’s hips and not his stomach.
4. A harness that is not properly tightened can be dangerous. Check
the harness adjustment and tighten whenever you put your child in
the child safety seat.
Loosening the harness
1. The harness is loosened by pressing the adjustment button of the
harness (under the seat cover) at the front of the seat. (5.11)
2. Press the lever that is marked with “ press ” down with one hand
while holding both harness straps with your other hand.
3. Pull the harness straps towards you to loosen the harness.
4. Be careful when adjusting the harness strap not to trap the harness
adjustment strap when you press the button down.
6. SEAT AND HARNESS REMOVAL.
Remove the seat harness
1. Release the height adjustment tape removing it from the mounting
plate (6.1 & 6.2).
2. From the back of the seat, unhook the harness protector connector
tapes and detach the harness from the metal connector of the
harness, pull the connector tape to detach completely from the
seat (6.3 & 6.4).
Remove the cover buckle protector and the lower harness
1. Turn the plate attached to the safety buckle so that they coincide
with the nearest slot and insert into the slots of the seat base and
then pass through the slots in the cover (6.5 & 6.6).
EN
Group 1/2/3