Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
ASSEMBLY
5
6
IMPORTANT: Test each top rail by pushing
down slightly to confirm each is rigid and
locked securely in place before use. (Fig. 4)
5. Place the Mattress on the floor of the Playard
with the padded side facing up. (Fig. 5)
6. Insert the three (3) Velcro® straps located on
the underside of the Mattress through the slots
in the floor of each end of the Playard (Fig.
6). Fasten the hook and loop straps to the
underside of the Playard floor to prevent the
Mattress from moving. (Fig. 7)
IMPORTANT: The handle located in the
center of the Playard floor MUST remain raised
(Approx. 45.7 cm or 18 inches) while locking
the side rails in place. If the center is not raised
the rails will NOT lock.
If you experience difficulty and one side of the
rail will lock but the other side will not then,
unlock the rail by squeezing the release in the
center and try again. If you still have difficulty,
contact our Customer Service Center at
1-800-328-7363 or visit us online at
www.babytrend.com.
7. To operate the brakes on the Wheels, press
downward on the brake levers. To release, lift
upward on the lever. (Fig. 8)
ATTENTION:
To use as a bassinet, skip to page 8 for bassinet
installation instructions.
FOLDING PLAYARD
1. Release the three (3) Velcro® straps holding
the Mattress from underneath the Playard floor
or the Bassinet and set the mattress aside.
2. Do not unlock top rails yet, center of floor must
be raised before top rails will unlock.
3. Rotate the center handle counter-clockwise
90 degrees and raise the center as high as the
top rails (Fig. 9). Gather the Legs and Wheels
together towards the center as close as possible
so that they nearly touch.
4. Locate the rail latch release in the center and
bottom side of each rail. Squeeze the lever
with two hands until the rail releases the
two tubes (Fig. 10), then push down (Fig.
11). NOTE: If the top rail(s) do not release
completely, DO NOT FORCE! Lift the center
of floor higher. Both tubes must be released
for the top rail to fold.
5. Gather four (4) corners and center all together
tightly (Fig. 12). Wrap Mattress around
Playard frame with padded side facing inward.
Secure the three (3) hook and loop straps by
feeding them through the loops on the end
of the Mattress and folding them back onto
themselves.
6. Wrap Mattress around Playard frame with
padded side facing inward.
7. Secure the three (3) hook and loop straps by
feeding them through the loops on the end
of the Mattress and folding them back onto
themselves. (Fig. 13)
8. Place folded Playard into carry bag so that the
handle comes through the opening between
each side of the zipper.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Rotate before
lifting
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 8
PRESS TO
UNLOCK
Tube
Tube
TOP RAIL
Latch
Release
