background image

In a crash, the safety seat provides no protection for your 

child unless the Harness Straps are properly installed 

according to these instructions.  Make sure that the harness 

straps are properly adjusted and secured whenever using 

the Safety Seat, even when using as a carrier.

Please follow these instructions carefully to properly 

secure your child.

14.1)

 Check that the Harness Straps are installed in the 

proper slots or adjusted to the proper height as 

described in section 12, Adjustment of the Shoulder 

Straps, preceding.

14.2)

 The clothing you dress your child in will affect 

the proper use of the Safety Seat.  Please dress 

your child in clothing that will:

• Allow the Harness Straps to securely latch 

between your child's legs.

• Keep the shoulder straps properly located on 

your child's shoulders.

14.3)

 Place the Safety Seat on a firm and level surface.

Move the carry handle to the non rocking 

position.  Loosen the Harness Straps by pulling 

on the straps while pushing on the Harness 

Adjuster Button located below the pad just in 

front of the buckle.  Unfasten the Harness Chest 

Clip.  Unbuckle the Harness Straps and drape the 

Harness Straps over the Seat back or to the sides 

of the Safety Seat.  Please see figure 37-1.

14.4)

 Place your child in the Safety Seat so that the 

child's bottom is against the back and bottom of 

the seat.  Please see figure 37-2.

14.5)

 Pull the harness straps down over your child.

Check that the harness straps are not twisted.

Failure  to  properly  secure  your  child  in  the  Safety  Seat  / 
Carrier  increases  the  risk  of  death  or  serious  injury  from 
suffocation or falls, or in the event of a sharp turn, sudden 
stop or crash.

14) Securing your Child in the Safety Seat / Carrier

14.6)

 For the EZ5 Harness:

14.6.1)

 Buckle the Harness Straps to the buckle between 

your child's legs.  Make sure you hear a click.

Pull on the Harness Straps to ensure that they are 

securely buckled.

If the harness straps are not 

securely buckled, the safety seat will NOT 

provide protection for your child.  DO NOT 

use the safety seat, even as a carrier, if the 

harness does not securely buckle.  Please call 

Baby Trend at (800) 328-7363 for assistance.

14.6.2)

 From the front of the Safety Seat, pull outward on 

the Harness Adjuster Strap to tighten the Harness 

Straps. Make sure that both Harness Straps are 

snug on your child's shoulders. A snug strap 

should not allow any slack. It lies in a relatively 

straight line without sagging. It does not press on 

the child's flesh or push the child's body into an 

unnatural position. Please see figure 38-1.

14.6.3)

 Fasten the Harness Chest Clips together.  Position 

the Harness Chest Clip, by sliding the Clip either 

up or down on the Harness Straps, so that it is level 

with the child's armpits.  Please see figure 38-2.

14.7)

 For the 5-Point Harness:

14.7.1)

 Put the two buckle tongues together, overlaying the 

left buckle tongue onto the right buckle tongue, and 

insert the two joined buckle tongues into the harness 

buckle on the crotch strap.  Make sure that you hear 

the tongues click into the buckle and check that both 

are firmly latched by pulling upward on the straps.  

Please see figure 39-1 and 39-2.

If the harness 

straps are not securely buckled, the safety seat 

will NOT provide protection for your child.  DO 

NOT use the safety seat, even as a carrier, if the 

harness does not securely buckle.  Please call 

Baby Trend at (800) 328-7363 for assistance. 

14.7.2)

 From the front of the Safety Seat, pull outward on 

the Harness Adjuster Strap to tighten the Harness 

Straps. Make sure that both Harness Straps are flat 

and tight on your child's shoulders. The harness is 

properly tightened if you are not able to insert more 

than one finger between the harness strap and your 

child's shoulder. Please see figure 38-1.

14.7.3)

 Fasten the Harness Chest Clips together.  Position 

the Harness Chest Clip, by sliding the Clip either 

up or down on the Harness Straps, so that it is level 

with the child's armpits. Please see figure 38-2.

Correct

Incorrect

Fig. 37-1

Fig. 38-1

Fig. 38-2

Fig. 39-1

Fig. 39-2

Fig. 37-2

Straps flat and tight 

one finger of space

Level with arm pits

39

38

37

36

Содержание FLEX-LOC
















Отзывы: