background image

BRAKES

WARNING: 

Always  set  brakes  when 

the  stroller  is  not  being  pushed  so  that  the 

stroller will not roll away.  Never leave stroller 

unattended  on  a  hill  or  incline  as  the  stroller 

may slide down the hill.

1.  To  engage  brakes,  apply  light  downward  pressure  to  the  brake  lever 

located on each rear wheel.  The stroller may require slight forward or 

rearward movement in order to line up the teeth on the brake with each 

wheel brake cluster.  See figure 13.  Check that the stroller will not move 

and that the brakes are properly applied.   To release, gently lift up on the 

brake lever.  See figure 14.  

CANOPY

1.  To open the canopy, push forward on the front frame of the canopies.  

To close canopy, pull the front edge toward the rear of the stroller until 

folded.  Always fold the canopy prior to folding the stroller frame.  Please 

see figure 15. 

2.  The canopy will ratchet forward or back to block the sun.  Pull forward on 

the front canopy frame tube to move forward.  Pull backward on the rear 

frame tube to move back.  

3.  To remove the canopy, press the lock button on the end of the male fitting 

while pulling upward on the canopy.  Please see figure 16.

TO REMOVE FRONT CHILD TRAY

1.  To remove front child tray, pull forward on the locking lever on the tray 

arms to unlock.  Please see figure 6.  Please note that you may attach or 

remove one end at a time.  Also, the tray may be released on either side 

and will swing away for easy access to your child.  Please see figure 7.

Do Not allow children near stroller while folding.

1.  Close the canopy as described in the Canopy section above.  The canopy 

may be folded forward to fold the stroller or, if you need to reduce the size 

of the folded stroller, may be folded back toward the rear of the stroller.

2.  Unbuckle rear standing safety belt. Please see figure 10.

3.  To fold the stroller slide the red fold latch safety button in the center of the 

handle and squeeze the red handle while pushing forward on the handle.  

Once the stroller begins to fold, release the red handle and pull upward on 

the child tray until the stroller is folded.  Please see figure 17.  

4.  Secure the stroller in the folded position by latching the fold latch, located 

on  the  right  side  of  the  stroller handle, over  the  extended rivet on  the 

armrest.  You  may  have  to  rotate  the  front  wheels  to  fold  the  stroller 

completely.  Please see figure 18.

Fig. 15.

Fig. 16.

Fig. 17.

Fig. 13.

Fig. 14.

Release Button

Fold Button

Fig. 18.

TO FOLD STROLLER

6

Содержание 7315 LX-PT








Отзывы: