68
UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
9
Raise the buttonhole lever to its original
position.
0
Insert a pin along the inside of one bar tack at
the end of the buttonhole stitching to prevent
the stitching from being cut.
1
Pin
a
Use the seam ripper to cut towards the pin
and open the buttonhole.
1
Seam ripper
For keyhole buttonholes, use the eyelet punch
to make a hole in the rounded end of the
buttonhole, and then use the seam ripper to cut
open the buttonhole.
1
Eyelet punch
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
■
Changing the density of the stitching
Press the stitch length adjustment button, and
then slide the stitch length adjustment slider
to adjust the stitch length.
1
Stitch length adjustment slider
2
Stitch length adjustment button
• For details, refer to “Adjusting the stitch
length” (page 48).
• If the fabric does not feed (for example, if it is
too thick), decrease the density of the
stitching.
■
Changing the stitch width
Press the stitch width adjustment button, and
then slide the stitch width adjustment slider
to adjust the stitch width.
1
Stitch width adjustment slider
2
Stitch width adjustment button
• For details, refer to “Adjusting the stitch
width” (page 47).
Memo
●
Before sewing buttonholes, check the stitch
length and width by sewing a trial
buttonhole on a scrap piece of fabric.
●
When opening the buttonhole with the
seam ripper, do not place your hands in
the cutting direction, otherwise injuries
may result if the seam ripper slips.
1
1
1
CAUTION
1
2
1
2
Содержание Tempo BLTP
