Buttonhole Stitching/Button Sewing
S-18
e
Adjust the stitch width so that it is the same as the
distance between the holes in the button.
f
Place the button in the position where it will be sewn,
and lower the presser foot lever.
1
Button
• When attaching four-hole buttons, first sew the two
holes closest to you. Then, slide the button so that
the needle goes into the two holes toward the rear of
the machine, and then sew them in the same way.
g
Turn the handwheel toward you (counterclockwise) to
check that the needle correctly goes into the two holes
of the button.
If it seems as if the needle will hit the button, remeasure
the distance between the holes in the button. Adjust the
stitch width to the distance between the buttonholes.
h
Start sewing.
Set the sewing speed controller to the left (so that the
speed will be slow).
→
The machine automatically stops after sewing
reinforcement stitches.
i
Use scissors to cut the upper thread and the bobbin
thread at the beginning of the stitching.
Pull the upper thread at the end of the stitching to the
wrong side of the fabric, and then tie it with the bobbin
thread.
j
When you are finished attaching the button, slide the
feed dog position switch, to
(to the right as seen
from the rear of the machine) and turn the handwheel
to raise the feed dogs.
CAUTION
• When sewing, be sure that the needle does not
touch the button, otherwise the needle may
bend or break.
a
Memo
• The feed dogs come up when you start sewing
again.
Содержание PRESTO
