Baby Lock esante BLN, Инструкция и справочник

Страница: 136 / 189

SEWING AN EMBROIDERING PATTERN
Em
br
oi
de
ry
135
5
If the Bobbin Runs Out of Thread
If the bobbin begins to run out of thread during
embroidering, the machine stops and the following
message appears. Replace the bobbin thread according
to the following procedure. If very little sewing remains,
press to sew 10 stitches without rethreading the
machine.
The machine stops after sewing the 10 stitches.
a
Press .
b
Press the “Thread Cutter” button to trim the
threads.
c
Press the “Presser Foot Lifter” button to raise
the presser foot.
d
Raise the frame-securing lever, and then
remove the embroidery frame.
e
Replace the bobbin with a full one, and then
reattach the embroidery frame.
f
Press the “Presser Foot Lifter” button to lower
the presser foot.
g
To return to the point in the pattern where
sewing was stopped, follow steps
c
through
f
in the next section.
If the Thread Breaks During Sewing
a
Press the “Start/Stop” button to stop the
machine.
b
If the upper thread broke, rethread the
machine. If the bobbin thread broke, follow
the instructions in steps
a
through
f
from
the previous section to reinstall the bobbin.
c
Press .
Note
• Be careful not to apply a strong force to the hooped
fabric.
• When removing and reattaching the embroidery
frame, do not allow the frame to hit the carriage or
the presser foot, otherwise the pattern may become
misaligned.
Memo
For best results, return to a point 2 or 3 stitches before
sewing stopped.