36
Figure 49
Figure 50
Press the “Main” button to return to the “Regulated” or
“Manual” menu screen or the “Back” button to return to
the “More” menu screen.
Calibrate Tension
The Tension button enables you to calibrate the tension
device
(Figure 49)
. You should only calibrate the ten-
sion device under the direction of Baby Lock.
While calibrating the tension, you will be asked to do
the following:
1. Remove the tension knob.
2. Gently press the spring against the tension discs
while not compressing the spring.
3. While holding the spring in place, press Reset.
4. When calibration is complete, replace the tension
knob.
Speed Sensor Test
The “Speed” Sensor test can help you determine whether
or not there is a problem with the Baby Lock Crown
Jewel III speed sensor. Before performing this test,
remove the bobbin case and the top thread. Press the
“Start” button and the handwheel and needle bar will
begin moving slowly rotating. The white box will show
a number that should stabilize at 100 if the sensor is
functioning properly. Pressing “Start” again will stop
the machine
(Figure 50).
Press the “Main” button to return to the “Regulated” or
“Manual” menu screen or the “Back” button to return to
the “More” menu screen.
Содержание Crown Jewel III BLCJ18-3
Страница 1: ...3 ...
